 |
 |
 |
|
|
|
[Sponsors] | ||||
July 26, 2017, 23:58
|
Error - disabling writing of transcript file
|
#1 |
|
New Member
Join Date: Aug 2016
Posts: 14
Rep Power: 9  |
Hello everyone,
I'm getting "An error occurred in fluent when disabling writing of transcript file" when updating design points using workbench, maybe it runs properly like two or three points but then it just keep "solving" in the progress bar and I have to abort the simmulation. Hope you can help me finding the issue and maybe the solution. |
|
|
|
|
|
October 17, 2017, 07:53
|
An error occurred in fluent when disabling writing of transcript file
|
#2 |
|
New Member
frety
Join Date: Jul 2015
Posts: 9
Rep Power: 10 |
Hello,
did you a found a solution for your problem? |
|
|
|
|
|
 |
| Tags |
| design points, error |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |
| [swak4Foam] build problem swak4Foam OF 2.2.0 | mcathela | OpenFOAM Community Contributions | 14 | April 23, 2013 13:59 |
| ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
| DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |
Linear Mode
