|
[Sponsors] |
September 27, 2017, 15:38 |
Boundary Condition
|
#1 |
Member
CWL
Join Date: Nov 2015
Posts: 58
Rep Power: 10 |
I am simulating (turbulent) air flow across a long slab (as shown in the figure). Due to the size of the problem, I am thinking of simulating only a thin layer in the centre of slab as shown. However, I am not sure what boundary condition should I put on the two sides of the control volume (the green surfaces). I tried using the outflow condition but Fluent returned the error that outflow BC cannot be use together with a pressure outlet BC.
Does anyone has any idea? Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Accessing multiple boundary patches from a custom boundary condition file | ripudaman | OpenFOAM Programming & Development | 0 | October 22, 2014 18:34 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |