|
[Sponsors] |
October 27, 2017, 09:19 |
Inflation, invalid method
|
#1 |
New Member
Darma Yuda
Join Date: Sep 2017
Location: Germany
Posts: 18
Rep Power: 8 |
Hallo,
I'm trying to use the tool 'Inflation'. I have made my mesh and I just need to add some inflation for the boundary layer around the blades. But, I always see under the 'Inflation-Definition-Active-No, Invalid Method'. After I've updated my mesh, a cross instead of a check Symbol beside the inflation on the Outline appeared. (see attachment) When I tried to use with similar model, but without other Mesh Control-Method, the Inflation can be created. So my question is, can this inflation only be created, when tetrahedrons meshing is used on the Body? Thanks. Best regards, Darma Yuda |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Problems with creating a hex-uniform MultiZone Mash with Inflation | AnnaF | ANSYS Meshing & Geometry | 4 | April 19, 2019 06:24 |
[ANSYS Meshing] fail to use inflation method | saeedakhavan | ANSYS Meshing & Geometry | 2 | August 15, 2016 11:58 |
Error in compiling new drag model | k.farnagh | OpenFOAM Programming & Development | 13 | May 21, 2016 03:08 |
Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x | Saxwax | OpenFOAM Installation | 25 | November 29, 2013 05:34 |
OpenFOAM install on Ubuntu Natty 11.04 | bkubicek | OpenFOAM | 13 | May 26, 2011 05:48 |