|
[Sponsors] |
March 30, 2018, 03:32 |
RSM without wall function
|
#1 |
Member
Michal
Join Date: May 2017
Posts: 35
Rep Power: 9 |
Hey there!
I am trying to compare simulation performed with k-w SST with RSM. My mesh prepared for k-w has very fine mesh with boudary layer (y+~1). As far I know (and read), RSM uses wall function. Is it possible to simulate flow without using any wall function in order to calculate heat transfer between the wall and the fluid properly? Otherwise, mesh should have y+>30 right? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[mesh manipulation] RefineMesh Error and Foam warning | jiahui_93 | OpenFOAM Meshing & Mesh Conversion | 4 | March 3, 2018 11:32 |
What's the problem with turbulence models near the wall region? | Jaydi_21 | Main CFD Forum | 6 | July 7, 2017 02:39 |
[swak4Foam] installation problem with version 0.2.3 | Claudio87 | OpenFOAM Community Contributions | 9 | May 8, 2013 10:20 |
Use of enhanced wall function in the RSM viscous model for a 3D sector | a.hasan | FLUENT | 0 | March 27, 2012 07:40 |