|
[Sponsors] |
October 19, 2018, 11:01 |
Low results in CL and CD at a 3d naca0012
|
#1 |
New Member
Greece
Join Date: May 2017
Posts: 20
Rep Power: 9 |
Good evening
i have a problem with my results in ansys fluent as i get the cl at 8 deegree aoa (which i have set through boundary conditions ) at a e.t.c 1.004*10-2 which ofc is extremely low. My domain is water. I have attached pictures of the mesh. I have done the same analysis at a 2d hydrofoil naca0012 and the results were something like 0.6, 0.8 which were ok according to papers. I have used standard k-epsilon. My question is if the problem is in DM in MESH or in FLUENT Setup. Thanks very much in advance (if you need other pictures i can provide them ) |
|
|
|