[helios95]

Hi everyone,


I am interested in inspecting the surface incident radiation that the walls of the different components inside a chamber receive from a surface that I will draw. For this simulation, the conduction of heat is unnecesary.


Since all the components inside the chamber have already been meshed separately (i.e. the overall model was not enclosured) and they are several and with complex geometries, is there any way of adding the meshing of the volume between them without any problem (or even omitting the meshing of the volume for the S2S model as in Workbench)?



Thanks in advance



P.S. Since only the radiation interests me, is there any way of "switching off" the calculation of the heat conduction, so the simulation can run faster?