|
[Sponsors] |
June 17, 2019, 05:34 |
Problem in Heat Transfer in Inner Tube
|
#1 |
New Member
Ali
Join Date: May 2019
Posts: 11
Rep Power: 7 |
Hi,Everyone hope all of you are good in health and doing well. I am using fluent
to heat transfer between two circular tubes.after the completion of simulation I check Results. when i see temperature contour there is nothing change in inner tube but the heat is transfer occurred in mid wall.But In Temperature Contour Color is same from start to end. What do You thinks what's the problem with this why heat transfer did't show in inner tube. I also Attached Temperature contour with Please Aslo check that. Thanks in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Inverse and Transient Heat Transfer Problem on commercial software: is it possible? | rogbrito | Main CFD Forum | 1 | February 19, 2019 02:11 |
Evaporation-Condensation in a porous zone (Heat transfer problem) | maximilian-1 | Fluent Multiphase | 1 | August 22, 2018 09:42 |
fluent conjugate heat transfer problem | eling | FLUENT | 9 | October 21, 2017 10:10 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |