|
[Sponsors] |
July 23, 2019, 12:19 |
Problem In Setup: NO all Cell Zone
|
#1 |
New Member
marianna
Join Date: Mar 2016
Posts: 10
Rep Power: 10 |
Hi to everyone!
I hope that you can help me. I did a drawing, after i did a mesh without the problem, but when i tried to do a setup..surprise!!! There aren't some bodies!!! how is it possible?? MESH Mesh.jpg SETUP Setup.jpg Last edited by mame; July 24, 2019 at 08:11. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Case setup with multiple heat generating bodies | miragemobile | OpenFOAM Pre-Processing | 2 | May 2, 2019 08:32 |
Case setup with multiple heat generating bodies | miragemobile | OpenFOAM | 0 | May 1, 2019 10:10 |
[ANSYS Meshing] ANSYS 2D Geometry/Meshing Plugin Error: Attach Failed, No Valid Bodies Found | cdase | ANSYS Meshing & Geometry | 0 | August 26, 2018 14:31 |
2D Glass Melt Simulation Setup | marmz | FLUENT | 5 | October 9, 2016 15:25 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |