|
[Sponsors] |
August 20, 2019, 03:24 |
Help on specifying the value of viscosity
|
#1 |
Member
MWRS
Join Date: Apr 2018
Location: Islamabad
Posts: 99
Rep Power: 8 |
Hello everyone,
From the tutorial of Fluent, it is recommended to set the viscosity in fluid material as three coefficient method Sutherland Law for high speed compressible flows. Since my problem setup is at an altitude and based on that altitude I have a viscosity value, where do I place this value in ansys fluent? Is it on the reference viscosity field? or does the default settings are self calculating the value of viscosity using the relevant static temperature? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic viscosity and Kinematic viscosity | asal | FLUENT | 7 | September 3, 2019 01:25 |
Problem with divergence | TDK | FLUENT | 13 | December 14, 2018 06:00 |
driftFluxFoam viscosity model modification problem | dleduc | OpenFOAM Programming & Development | 15 | October 1, 2018 09:37 |
Ratio of eddy viscosity to molecular viscosity : Laminar or turbulent flow? | JuPa | CFX | 7 | September 9, 2013 07:45 |
Too low temperature at combustor outlet | romekr | FLUENT | 2 | February 6, 2012 10:02 |