|
[Sponsors] |
Pouring simulation - Spilling due to adhesion of fluid to container |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 16, 2019, 11:20 |
Pouring simulation - Spilling due to adhesion of fluid to container
|
#1 |
New Member
Daniel
Join Date: Apr 2018
Posts: 24
Rep Power: 8 |
I was wondering if it is possible to simulate the effect fluid adhesion during a pouring test using fluent.
I will like to predict if the water will stick and run down the outside wall of the container when pouring water at a certain angle. However have not been able to find any solutions for similar problems with fluent. Something like this: https://www.youtube.com/watch?v=Dqwq4D8XXg0 Can someone give me guidance on this issue? Thanks. Last edited by dsaen; October 16, 2019 at 19:12. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How do i Validate the starccm+ Squat simulation of KCS container ship in restricted | agnayts | STAR-CCM+ | 0 | December 17, 2018 01:06 |
Weird fluid distribution in the interMixingFoam simulation | HectorLee | OpenFOAM Running, Solving & CFD | 0 | July 11, 2018 09:55 |
Issue in simulation of open channel flow with high viscosity fluid | soleymm1 | STAR-CCM+ | 2 | December 3, 2017 01:44 |
Problem in CHT simulation with high heat capacity fluid | Fole | FLUENT | 1 | September 26, 2017 08:42 |
Problem with an old Simulation | FrankW | CFX | 3 | February 8, 2016 04:28 |