|
[Sponsors] |
February 11, 2020, 04:39 |
Issue with convergence criteria value
|
#1 |
Member
MMatt
Join Date: May 2013
Posts: 59
Rep Power: 13 |
Using Fluent 2019R1, I am facing an annoying issue. I created a report-definition, whose value is around 2e-10. However, when trying to set a convergence condition on this value, I can only input 1 decimal.
The issue is that I need to specify something like 1.835e-10 as a convergence criteria, but it keeps on setting it back to 1.8e-10 which is not acceptable. Is there a way to increase the number of decimals? I've tried to create an expression that multiplies this value by 10^10 so then I can have more decimals, but this doesn't quite work right. Thanks in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Square duct flow with cyclic inlet outlet - simpleFoam Convergence issue | Vino | OpenFOAM Running, Solving & CFD | 7 | January 25, 2019 02:55 |
SIMPLE: no convergence criteria found | Gennaro | OpenFOAM Programming & Development | 3 | October 21, 2018 00:08 |
question about convergence criteria in Flow Simulation | drdet | FloEFD, FloWorks & FloTHERM | 2 | January 16, 2015 09:36 |
Individual convergence criteria for velocity components? | CoolHand | OpenFOAM Running, Solving & CFD | 0 | March 3, 2014 16:47 |
Convergence Criteria | edwin | FLUENT | 1 | February 14, 2008 19:24 |