[hassanayaz]

i have used non-conformal periodic zone for 3D geometry..... when i do initialization first time after creating non-conformal periodic zones then no error shown in console but when do re-initialization then the following error shown.... same for other two boundaries
Error: Non-conformal periodic interface inlet-outlet with empty intersection.
This is likely due to incorrect specification of periodic
offset values. Please check the offset values specified
and recreate the interface.
what could be the problem?????????

[alejandro_1980]

Originally Posted by vinerm

%t and %i can be used for writing but not for reading a file. You have to use scheme command to read those files.

(ti-menu-load-string (format #f "file read-profile name_~04d.prof" (rpgetvar 'time-step)))

where you need to replace name_ with actual basename. 04 specifies number of 0s before value at the end. So, if the file name is name_0003.prof, then the command above will read it. If it is 00003, then use 05 in place of 04.

Dear Vinem, how can i read profiles named run0001.prof, run0002.prof and so on? May you provide me the modification to your previous entry?