|
[Sponsors] |
July 29, 2020, 04:18 |
Mesh problem
|
#1 |
Member
Francesco
Join Date: Apr 2020
Posts: 56
Rep Power: 6 |
Hi everybody.
I'm performing a thermal analysis on Fluent and i have a problem about the mesh. In the figure i uploaded you can see that the mesh lines on the external disk are just inclined with respec to the one of the internal, which are towards to the radial direction. How can i make also the external mesh lines radial? Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" | GuiMagyar | OpenFOAM Meshing & Mesh Conversion | 3 | August 4, 2023 12:38 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
[ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |