|
[Sponsors] |
December 10, 2020, 12:20 |
What boundary condition should i use?
|
#1 |
New Member
harshavardhanps
Join Date: Dec 2020
Posts: 13
Rep Power: 5 |
I am designing low speed open type sub sonic wind tunnel(Mach NO~0.1). I completed my geometry and meshing i got struck at what boundary conditions should i use? Currently I am using Patm(static pressure inlet= atmospheric gauge pressure i.e Patm=0 pa) and mass flow rate boundary condition as outlet. Along with pressure inlet I am giving 0.5% turbulent intensity and 1 cm turbulent length scale. Are these boundary conditions correct?
please help me your help is much appreciated. Last edited by harshavardhanps3839; December 11, 2020 at 05:59. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
Accessing multiple boundary patches from a custom boundary condition file | ripudaman | OpenFOAM Programming & Development | 0 | October 22, 2014 18:34 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |