|
[Sponsors] |
December 14, 2020, 11:12 |
No Report Files when changing to Transient
|
#1 |
New Member
Join Date: Dec 2020
Posts: 3
Rep Power: 5 |
Hi,
I'm trying to run a transient solution using a previously converged steady-state solution with report files for things like CD, CL, CS, etc. I changed my model, solver settings, and then edited my report-files to set frequency-of to time-step and the itr-index to 626 as my converged solution is set to 625 steps. However, Fluent is not writing anything to these files. I've double checked all of the reports are active and even tried adding completely new report-files and definitions but nothing is being written. I'm not sure if this is an error due to a mismatch between the previous iterations and then switching to a time-step? I don't have it set to flow-time so I would've thought it would carried onto the next iteration as is. Thank you in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Script/Batch File to obtain transient data from FLUENT Saved Files | SSG_NJ | FLUENT | 0 | November 19, 2020 01:08 |
Could we set up report files for many surfaces at the same time in fluent,for exampl | hitzhwan | FLUENT | 0 | July 16, 2020 12:42 |
Transient boundary conditions changing type over time | LukeFullard | Fluent UDF and Scheme Programming | 0 | August 13, 2012 05:52 |
Creating Transient Graphs using Autosave files from FLUENT | koonalb | FLUENT | 2 | June 3, 2011 03:23 |
Results saving in CFD | hawk | Main CFD Forum | 16 | July 21, 2005 20:51 |