|
[Sponsors] |
January 11, 2021, 21:26 |
slurry viscosity
|
#1 |
Member
kim jihyun
Join Date: May 2020
Posts: 31
Rep Power: 6 |
hello,
i'm on a project which has wood particles. there are two inlets. at one inlet, 50mm wood particles are injected with water. here is the question. i want to know if syamlal-obrien and lun-et-al model are enough to simulate wood slurry viscosity, if not do i have to put in user defined viscosity? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
error after implementing a new viscosity model | Lee Kyun Bum | OpenFOAM Running, Solving & CFD | 0 | January 1, 2021 17:57 |
Identifying cells having Turbulent viscosity limited to viscosity ratio of 1.000e+05 | Sayantan Biswas | FLUENT | 0 | September 20, 2019 04:49 |
Dynamic viscosity and Kinematic viscosity | asal | FLUENT | 7 | September 3, 2019 01:25 |
Problem with divergence | TDK | FLUENT | 13 | December 14, 2018 06:00 |
Too low temperature at combustor outlet | romekr | FLUENT | 2 | February 6, 2012 10:02 |