Problem in Ansys Fluent, Macroscopic Particle model(MPM)

Achini · July 21, 2020, 10:35

Hello!
I'm trying to simulate a cinematographic separation using MPM(Macroscopic particle model) in Ansys fluent (2020 student version).

I have created a particle injection at the inlet of the channel and i'm using "particle track" option to tract the flow of the injected particle.

The problem is, when i run the simulation, the injected particles do not appear.
Can someone help me with this please?
Thank you!

mcgart25 · February 1, 2021, 12:40

Did you manage to figure out what the issue was? I am having the same problem myself, in nothing happens when I click on 'display injection'. The only issue I can think of is that in the only tutorial I could find (on Youtube by a company called Difotech), they created some kind of ASCII file in the 'write particle data' section'. I am not sure if such a file is needed to allow initialization. However, I am not sure what kind of information this file needs to contain. If you did find the issue, could you please contact me?

July 21, 2020, 10:35	Problem in Ansys Fluent, Macroscopic Particle model(MPM)	#1
Achini Member L.A.Isanka Join Date: Jul 2020 Posts: 55 Rep Power: 5	Hello! I'm trying to simulate a cinematographic separation using MPM(Macroscopic particle model) in Ansys fluent (2020 student version). I have created a particle injection at the inlet of the channel and i'm using "particle track" option to tract the flow of the injected particle. The problem is, when i run the simulation, the injected particles do not appear. Can someone help me with this please? Thank you!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
SU2-7.0.1 on ubuntu 18.04	hyunko	SU2 Installation	7	March 16, 2020 04:37
Problem with Results in ANSYS Fluent	mattsarg55	FLUENT	6	August 6, 2019 12:06
Multi-phase Problem in Ansys Fluent.	Deepakc	Fluent Multiphase	0	June 25, 2019 05:59
problem of running parallel Fluent on linux cluster	ivanbuz	FLUENT	15	September 23, 2017 19:12
error in ansys fluent while solving dynamic mesh problem of moving wall	classified	FLUENT	3	November 23, 2016 01:21

February 1, 2021, 12:40		#2
mcgart25 New Member Ethan McGrath Join Date: Feb 2021 Posts: 3 Rep Power: 5	Did you manage to figure out what the issue was? I am having the same problem myself, in nothing happens when I click on 'display injection'. The only issue I can think of is that in the only tutorial I could find (on Youtube by a company called Difotech), they created some kind of ASCII file in the 'write particle data' section'. I am not sure if such a file is needed to allow initialization. However, I am not sure what kind of information this file needs to contain. If you did find the issue, could you please contact me?