|
[Sponsors] |
February 5, 2022, 17:18 |
How to shift local coordinate system
|
#1 |
New Member
Anon
Join Date: Jan 2022
Posts: 4
Rep Power: 4 |
Hi,
I created my aircraft wing using CAD & imported it into ANSYS DesignModeler. However, I would now like to shift the local coordinate system to be at the wing leading edge. How can I go about doing this? Thanks |
|
February 6, 2022, 05:27 |
|
#2 |
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,679
Rep Power: 66 |
||
February 21, 2022, 06:03 |
|
#3 |
New Member
Anon
Join Date: Jan 2022
Posts: 4
Rep Power: 4 |
Thank you!!
|
|
Tags |
ansys2021 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
p_rgh initial residual no change with different settings | manuc | OpenFOAM Running, Solving & CFD | 3 | June 26, 2018 15:53 |
How can I fix a local coordinate system to the inlet | phys-zephyr | STAR-CCM+ | 3 | May 8, 2014 05:46 |
dynamic Mesh is faster than MRF???? | sharonyue | OpenFOAM Running, Solving & CFD | 14 | August 26, 2013 07:47 |
local coordinate system for porousZone | Nico A. | OpenFOAM Programming & Development | 0 | November 15, 2011 04:32 |
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |