|
[Sponsors] |
Does anyone know how to set the coupled wall boundary in the fluent by the code? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 15, 2022, 04:49 |
Does anyone know how to set the coupled wall boundary in the fluent by the code?
|
#1 |
Senior Member
Join Date: Dec 2017
Posts: 387
Rep Power: 9 |
Does anyone know how to set the coupled wall boundary in the fluent by the code?
|
|
April 17, 2022, 05:40 |
|
#2 |
New Member
Suraj A Bolaj
Join Date: Apr 2022
Posts: 4
Rep Power: 4 |
||
April 17, 2022, 20:42 |
Thank you for sharing your Vedio, but I use the fluent 6.3.26, could you tell me how
|
#3 | |
Senior Member
Join Date: Dec 2017
Posts: 387
Rep Power: 9 |
Quote:
|
||
April 22, 2022, 03:45 |
|
#4 |
New Member
Suraj A Bolaj
Join Date: Apr 2022
Posts: 4
Rep Power: 4 |
Sorry but I don't have much knowledge about fluent 6.3.26 as I am using ANSYS 19.1.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
Velocity vector in impeller passage | ngoc_tran_bao | CFX | 24 | May 3, 2016 21:16 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |