|
[Sponsors] |
Saving fluent file as (.mesh ascii) so I can convert it to OpenFOAM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 22, 2022, 11:23 |
Saving fluent file as (.mesh ascii) so I can convert it to OpenFOAM
|
#1 |
New Member
Bssam
Join Date: Nov 2019
Posts: 19
Rep Power: 6 |
Dear All,
How to save a fluent mesh (.mesh) in ascii format so I can convet it in openfoam using fluent3DMeshToFoam? I use workbench, so I start from geometry, then mesh, when I finish the mesh it automatically save it in the path shown in Figure 3, there is no even choice to save as .mesh! The mesh file show in Figure 2 is binary and openfoam cannot read it: // * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * // Create time Reading header: "ANSYS(R) TGLib(TM) 3D, revision 18.1.0" Dimension of grid: 3 Number of points: 10279396 --> FOAM Warning : Found unknown block of type: "11" on line 18 Number of faces: 13523098 Number of cells: 2543034 --> FOAM Warning : Found unknown block of type: "3010" on line 21 --> FOAM FATAL ERROR: Do not understand characters: on line 22 From function virtual int yyFlexLexer::yylex() in file fluent3DMeshToFoam.L at line 749. FOAM exiting But the mesh (.mesh) file in figure 1 (created by someone else I don't know) is working fine! Please help me |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Custom Thermophysical Properties | wsmith02 | OpenFOAM | 4 | June 1, 2023 14:30 |
[OpenFOAM.com] swak4foam compiling issues on a cluster | saj216 | OpenFOAM Installation | 5 | January 17, 2023 16:05 |
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0 | towanda | OpenFOAM Community Contributions | 6 | September 5, 2015 21:03 |
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 17:18 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |