 |
 |
 |
|
|
|
[Sponsors] | ||||
August 20, 2022, 07:14
|
Initial temperature of wall
|
#1 |
|
New Member
Zivota Lazarevic
Join Date: Mar 2021
Posts: 4
Rep Power: 5  |
Is there any way to set initial temperature of one wall, and simulate distribution of temperature when all other walls are adiabatic?
|
|
|
|
|
|
August 22, 2022, 01:49
|
|
#2 |
|
Senior Member
Alexander
Join Date: Apr 2013
Posts: 2,363
Rep Power: 34 |
easiest way:
define the name to the wall you are interested in while creating mesh, now you can apply other boundary condition
__________________
best regards ****************************** press LIKE if this message was helpful Last edited by AlexanderZ; August 22, 2022 at 06:20. |
|
|
|
|
|
|
August 22, 2022, 13:04
|
|
#3 |
|
Member
MIDHUN
Join Date: Nov 2012
Location: calicut
Posts: 46
Rep Power: 13  |
Yes, Name the wall in MESHING
Then give initial temp to the wall during INITIALIZATION |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HeatSource BC to the whole region in chtMultiRegionHeater | xsa | OpenFOAM Running, Solving & CFD | 3 | November 7, 2016 05:07 |
| Compressor Simulation using rhoPimpleDyMFoam | Jetfire | OpenFOAM Running, Solving & CFD | 107 | December 9, 2014 13:38 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |
Linear Mode
