|
[Sponsors] |
October 4, 2022, 04:27 |
Why this simulation is possible.
|
#1 |
Senior Member
Sangho Ko
Join Date: Oct 2021
Location: South Korea
Posts: 135
Rep Power: 4 |
Hello everybody~!
I have a question while runnig simulation. I've run simulation with wrong boundary condition. I've run simulation for pipe flow and set inlet properly. But I've set both wall and outlet to wall so that there is no flow out in this pipe. Even though there is no flow out in this simulation, simulation doesn't get bombed. In my opinion, even though convergence is just done without numerical problem, it is not representing proper physical situation but I'm not sure. Is it really possible? Actually I can't believe it that simulation is done properly in terms of numerical method even though I can see simulation is done with convergence. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence Problem - Transient Simulation | gemxx | Main CFD Forum | 0 | July 15, 2018 09:36 |
Mapping Field Data for Mesh Regions from Another Simulation | veterator | OpenFOAM Pre-Processing | 1 | July 10, 2018 05:28 |
Surface Source - Fixed Temperature? | robtheslob | FloEFD, FloWorks & FloTHERM | 18 | May 12, 2017 02:28 |
Simulation FPEs - turbulence for transient and steady-state? | DaveR | OpenFOAM Running, Solving & CFD | 5 | March 5, 2017 15:06 |
setting up a simulation with multiple interactions | phandy | OpenFOAM Running, Solving & CFD | 1 | October 6, 2014 03:16 |