|
[Sponsors] |
April 25, 2023, 12:00 |
Centrifugal pump simulation using fluent
|
#1 |
New Member
Ahmed
Join Date: Apr 2023
Posts: 8
Rep Power: 3 |
Hello everyone,
I am working on centrifugal pump simulation case via ansys software, I have set the boundary conditions of the case then by mistake I put the rotational speed 1500 rad/s instead of 1500 rpm the contours of pressure and velocity in these iteration were normal when I changed the rotational speed to 1500 rpm with the same settings and boundary conditions the contours were not normal and the residuals were not stable. Can someone help me to find out why the simulation goes wrong in the case of 1500 rpm? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
axial piston pump simulation in Fluent | Silence | FLUENT | 6 | September 13, 2024 06:49 |
How to set Outlet Guage Pressure in ANSYS Fluent for Centrifugal Pump? | PratikChalke | FLUENT | 0 | March 6, 2023 15:34 |
Centrifugal pump impeller simulation doesn't converge | JuanRincon | CFX | 8 | June 25, 2019 06:59 |
problem for centrifugal pump transient simulation | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | January 15, 2014 05:55 |
centrifugal pump simulation OK but result with 30% error | ARohit | FLUENT | 0 | January 1, 2014 02:54 |