Solving tracer homongenization in a stirred vessel

HWIK · May 6, 2023, 04:20

Hi, I am trying to compute the mixing time in a stirred vessel, I am modelling this in Fluent using MRF and SM approaches. For the MRF, given it is a steady state method, after resolving the flow profile in steady state, I just initialised the data in the vessel with that result and solved the tracer diffusion equation only, and not the flow equations in a transient simulation to predict the the change in concentration over time.
I want to do something similar with the sliding mesh, I have the flow profile resolved, could I then use a similar approach to tracking tracer difusion in the stirred vessel? So, turning of tracer the solution for the flow equations and only solving the tracer equation?

NickFL · May 6, 2023, 15:33

With a sliding mesh approach, you will have to solve for the flow equations too. That is unless you have an unbaffled tank where the time-averaged and each instantaneous flow field is the same.

May 6, 2023, 04:20	Solving tracer homongenization in a stirred vessel	#1
HWIK New Member Aloha Join Date: May 2023 Posts: 1 Rep Power: 0	Hi, I am trying to compute the mixing time in a stirred vessel, I am modelling this in Fluent using MRF and SM approaches. For the MRF, given it is a steady state method, after resolving the flow profile in steady state, I just initialised the data in the vessel with that result and solved the tracer diffusion equation only, and not the flow equations in a transient simulation to predict the the change in concentration over time. I want to do something similar with the sliding mesh, I have the flow profile resolved, could I then use a similar approach to tracking tracer difusion in the stirred vessel? So, turning of tracer the solution for the flow equations and only solving the tracer equation?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with chtMultiregionFoam radiation boundary condition	baran_foam	OpenFOAM Running, Solving & CFD	10	December 17, 2019 17:36
HeatSource BC to the whole region in chtMultiRegionHeater	xsa	OpenFOAM Running, Solving & CFD	3	November 7, 2016 05:07
Floating point exception error	lpz_michele	OpenFOAM Running, Solving & CFD	53	October 19, 2015 02:50
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3	bookie56	OpenFOAM Installation	8	August 13, 2011 04:03

May 6, 2023, 15:33		#2
NickFL Senior Member Join Date: Jun 2009 Location: Technische Universität Chemnitz Posts: 107 Rep Power: 16	With a sliding mesh approach, you will have to solve for the flow equations too. That is unless you have an unbaffled tank where the time-averaged and each instantaneous flow field is the same.