|
[Sponsors] |
May 16, 2023, 05:04 |
Freeze one cell zone
|
#1 |
Senior Member
Davide
Join Date: Jul 2015
Posts: 107
Rep Power: 10 |
Hi,
I would to know if in Fluent in a simulation with two different cell zone is possible to freeze the numerical solution of one cell zone after some timestep by keeping at the interface the same coupling. Thank you Best regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] Unknown error when converting fluent mesh to openfoam | Yutao | OpenFOAM Meshing & Mesh Conversion | 0 | April 23, 2023 02:30 |
[snappyHexMesh] Error when setting locationsInMesh | elonesampaio | OpenFOAM Meshing & Mesh Conversion | 1 | April 3, 2021 17:44 |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |