|
[Sponsors] |
After Surface mesh, the model consists of 1 fluid/solid regions and 1 voids. |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
New Member
Join Date: Apr 2023
Posts: 15
Rep Power: 3 ![]() |
Im creating a mesh for a fixed wing UAV, after importing the CAD geometry, preparing it and creating an enclosure, creating the named selection and going to the fluent mesher, I create the surface mesh and I get the message that my geometry consists of 1 fluid/solid regions, and 1 VOID. Im pretty sure I should only have 1 fluid region and I know I can describe the geometry later to make sure that its only fluid however, is this something to worry about?.
|
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
flow over cylinder in openFoam | saeed jamshidi | OpenFOAM Pre-Processing | 3 | August 11, 2023 15:16 |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |