 |
 |
 |
|
|
|
[Sponsors] | ||||
November 5, 2023, 15:56
|
DPM wall boundary condition
|
#1 |
|
New Member
Join Date: Oct 2023
Posts: 13
Rep Power: 2  |
Hello friends, good time
In the DPM boundary conditions of the wall, I want to change the default value of the angle from minimum to 0 radians to maximum 90 radians. But after doing the work, it returns to the default state. Is it possible to change the range and in what form??? Untitled2.png Thank you in advance Ahmad Veis |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ansys CFD-Post Application Error | rushiCFD | FLUENT | 0 | March 21, 2021 07:51 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
| Natural convection in a closed domain STILL NEEDING help! | Yr0gErG | FLUENT | 4 | December 2, 2019 00:04 |
| Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 11:19 |
Linear Mode
