Home > Forums > Software User Forums > ANSYS > FLUENT

Dynamic mesh 6DOF Ansys fluent

Updated Threads

Reply

Search this Thread

December 26, 2023, 01:23	Dynamic mesh 6DOF Ansys fluent	#1
shubhamlad3 New Member Shubham Join Date: Sep 2023 Posts: 1 Rep Power: 0	Hello I am running dynamic mesh simulation of turbine which is incline on 22 degree. i am trying to capture torque and power generate using 6DOF solver. After complete run when i am looking dynamic mesh zone theta value change to 120 degree ideally theta should be same. why such behavior?

Reply

Tags

#cfd #ansys #fluent

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Workbench] Extract a part of a 3D mesh in ANSYS workbench fluent	Mohamad Younes	ANSYS Meshing & Geometry	0	May 17, 2023 05:46
[ANSYS Meshing] Difficulty in mesh upload to ansys fluent	Ayo_gboyega	ANSYS Meshing & Geometry	1	June 17, 2018 03:02
Interesting problem: Parallel Processor VOF Fluent + Dynamic Mesh + System Coupling	spaceprop	FLUENT	5	September 2, 2014 09:43
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
The fluent stopped and errors with "Emergency: received SIGHUP signal"	yuyuxuan	FLUENT	0	December 3, 2013 22:56

All times are GMT -4. The time now is 06:48.