|
[Sponsors] |
September 14, 2000, 02:50 |
FLUENT 2D
|
#1 |
Guest
Posts: n/a
|
I am modelling a plane slider bearing in 2d using GAMBIT. The solution is done using FLUENT 5 solver.
The problem I encounter is - The pressure profile on the stationary wall gives me a negative value at the inlet, while actually it sholud be positive. Rest of the profile builds to a positive value after the initial dip. I know that FLUENT solves the Bernoulli equation at the inlet. But that's the problem here. I have tried using a finer grid/grid adaptation etc. but the results are the same. Is there a way of getting over this problem? PAI |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
A Problem of Fluent Interpreted UDF: parse error | knight | Fluent UDF and Scheme Programming | 25 | August 16, 2018 10:26 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Compared MRFSimpleFoam and Fluent in a centrifugal pump! | renyun0511 | OpenFOAM Running, Solving & CFD | 8 | July 6, 2010 06:24 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |