|
[Sponsors] |
March 23, 2002, 08:53 |
Unite faces problem
|
#1 |
Guest
Posts: n/a
|
Hi all,
I'm trying to unite 2 faces with 2 common edges. Face.1 is ( and face.2 is ). They are real. The geometry comes from an IGS file created with CENTAUR (imported as GENERIC). Issue#1: my unite face window title say "UNITE FACES" and not "UNITE REAL FACES" as described in Gambit manual. Issue#2: unite operation seems to be performed but no new face is generated Command> face unite faces "face.20" "face.21" real Uniting faces face.20 and face.21 And there it stops!!! Any clue about what's going on? Many thanks, Alex |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem : "reversed flow in 77 faces on outflow 12." | aliamini | FLUENT | 15 | February 6, 2014 14:06 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
problem due to reconstructPar? | doubtsincfd | OpenFOAM | 0 | June 3, 2011 16:16 |
Converting Virtual Faces to Real Faces in Gambit | gstraw | Main CFD Forum | 0 | June 19, 2009 07:11 |
Error to re-open fluent case file | J.Gimbun | FLUENT | 0 | April 27, 2006 08:42 |