 |
 |
 |
|
|
|
[Sponsors] | ||||
June 17, 2002, 12:49
|
Reverse Flow
|
#1 |
|
Guest
Posts: n/a
|
I am running a unsteady compressible problem using coupled implicit solver mode. The problem is a thin film with the lower wall stationary and the upper wall oscillating at high frequency. Each side exits are set as Pressure outlet at 0 gauge. The problem is, it keeps reporting reverse flow on both of those outlet, even if I change them to Pressure inlets. Is is an error message?
|
|
|
||
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reverse Flow | Bharati | FLUENT | 0 | September 14, 2010 01:09 |
| Flow simulation in reverse drum mixer | Patel Chirag | CFX | 0 | July 19, 2010 15:05 |
| reverse flow | alikami | FLUENT | 1 | June 2, 2010 04:19 |
| Reverse flow in the VOF model | yan | FLUENT | 1 | May 26, 2005 09:14 |
| reverse flow | Giovanni | FLUENT | 11 | October 15, 2001 03:01 |
Threaded Mode
