|
[Sponsors] |
August 30, 2002, 09:38 |
Non Posivtive Volumes
|
#1 |
Guest
Posts: n/a
|
Dear Fluent users
I created mesh in gambit, after importing it into fluent,while Checking Grid command it gives following errors WARNING: non-positive volumes exist. minimum volume (m3): -2.795385e-08 maximum volume (m3): 2.517220e+00 total volume (m3): 1.155276e+0 Zone 52: 358056 right-handed, 4 left-handed WARNING: Grid check failed. at the time of exporting I found Two warnings in my Gambit Transcript window ^ WARNING(2) - d:: NO SUCH FILE OR DIRECTORY A default (unspecified) continuum entity was created. A default (unspecified) boundary entity was created. K.MuraliKrishna |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with Volumes Gambit | Danath | ANSYS | 1 | October 19, 2011 08:20 |
[GAMBIT] Connecting volumes | makaero | ANSYS Meshing & Geometry | 4 | April 15, 2010 19:18 |
merging faces on a copied volumes | kunal | FLUENT | 0 | March 20, 2008 06:50 |
Connecting of two volumes | Kim | FLUENT | 3 | September 21, 2004 00:59 |
union of volumes | CHUBBY | FLUENT | 2 | May 4, 2001 06:31 |