|
[Sponsors] |
November 6, 2003, 07:14 |
Change BC during the run?
|
#1 |
Guest
Posts: n/a
|
Hi, all,
Is it possible for me to use some kind of BC seetings to get an initial flow field after certain iterations, and then change the BC and continue the run untill converged? For example, I use a guessed temperature level at a wall to get an initial solution, and then change the temperature condition for that wall to constant heat flux condition and hope to get the real solution. I don't know how fluent saves case information, but I feel if I continue the iterations from previous saved .cas and .dat files, fluent always picks up the previous boundary condition seetings and does not take the newly modified BC. How can I do this? Thanks, jx |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Solid/liquid phase change | fabian_roesler | OpenFOAM | 10 | December 24, 2012 06:37 |
Windows 64-bit, Distributed Parallel Run Issues... | Erich | CFX | 3 | March 28, 2006 16:36 |
problems with LES run | Tim | CFX | 1 | February 27, 2006 07:28 |
no enthalpy change across the momentum source | Atit Koonsrisuk | CFX | 2 | December 19, 2005 02:33 |
Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 05:12 |