|
[Sponsors] |
April 19, 2004, 14:45 |
UDF Beginner
|
#1 |
Guest
Posts: n/a
|
I am new to Fluent and UDF's. My problem. I have two cubes stacked on top of each other with a gap of 0.06 inch between the cubes. The cubes are attached by a cylinder and where all have been unioned. My problem is that I am to create a UDF at the pressure outlet of the top cause so that the mass flow rate through the hole between the two cubes is held constant. I have read the UDF manual and I am confused. What would be the best way to start the UDF? Any Help?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh UDF | Qureshi | FLUENT | 7 | March 23, 2017 07:37 |
UDF parallel error: chip-exec: function not found????? | shankara.2 | Fluent UDF and Scheme Programming | 1 | January 16, 2012 22:14 |
How to add a UDF to a compiled UDF library | kim | FLUENT | 3 | October 26, 2011 21:38 |
UDF, UDF, UDF, UDF | Luc SEMINEL | Main CFD Forum | 0 | November 25, 2002 04:01 |
UDF Beginner | M. A. Rakib | FLUENT | 1 | June 6, 2000 11:23 |