|
[Sponsors] |
March 3, 2005, 03:43 |
volume meshing-Urgent
|
#1 |
Guest
Posts: n/a
|
Hi everyone, I have a problem with meshing. I am a new starter and have gone through a model that has two volumes with an upper partition and a lower one, In practice thats how it should be. I have been able to export the mesh for the volumes into fluent but its taken ages to converge. has anybody got a clue what am doing wrong and how i can get the best out put? Thank you
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Volume Meshing with intended Voids | Will Anderson | ANSYS Meshing & Geometry | 5 | September 16, 2011 08:38 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[mesh manipulation] polyDualMesh and volume calculation... | jbf | OpenFOAM Meshing & Mesh Conversion | 2 | September 15, 2009 18:37 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |