|
[Sponsors] |
April 1, 2005, 03:02 |
Question about convergence criteria?
|
#1 |
Guest
Posts: n/a
|
Hello,
just a short question. When I want to be sure that my solution is converged, then the report->fluxes->total heat transfer rate for all surfaces should sum to zero (or near to zero). Is this right?? Or is there another posibillity to be sure about convergence. In my actuall problem the residuals are all below the fluent default criteria (e.g. 0.001 for conti) The continuity is at about 0.00014, but the total heat flux report is far away from zero. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convergence criteria | steventay | CFX | 6 | May 14, 2010 12:48 |
Convergence criteria of Solid liquid two phase flow. | trystwithgaurav | FLUENT | 0 | August 17, 2009 17:48 |
star-ccm+ convergence criteria | star | Siemens | 2 | January 14, 2009 04:57 |
Convergence criteria | Gaurav | Siemens | 0 | February 3, 2006 04:53 |
convergence criteria | co2 | FLUENT | 5 | May 20, 2004 09:52 |