|
[Sponsors] |
June 26, 2005, 13:02 |
Discrete Phase Model- Two Way Coupling
|
#1 |
Guest
Posts: n/a
|
When using the discrete phase model with two way turbulence coupling I find that the particles don't seem to change the fluid velocity. I am not sure what the cause of this is. I run the particles through every 30 fluid iterations. There is an initial affect on the residuals through the source term but then the fluid just seems to go back to it's converged single phase state. Is it may be the fact that the new source term doesn't remain for all the 30 fluid iterations, so doesn't get chance to affect the fluid?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Discrete Phase Model | vittal | FLUENT | 4 | October 28, 2014 10:07 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 03:32 |
Discrete phase model | cfdkhashayar | FLUENT | 4 | November 1, 2011 01:29 |
Discrete Phase Model (bubbles stuck in an eddy) | sahraaan | FLUENT | 0 | September 8, 2011 00:32 |
Help for INJECTION OR DISCRETE PHASE MODEL | MANOJKUMAR | FLUENT | 0 | December 27, 2005 04:05 |