|
[Sponsors] |
Starting 3D simulation with ideal gas – f.p.error |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 5, 2005, 06:59 |
Starting 3D simulation with ideal gas – f.p.error
|
#1 |
Guest
Posts: n/a
|
Hi,
I am running a simulation of a 3D geometry with air at constant density and it works very fine. Now I changed the air properties to ideal gas (there are up to 3 bars pressure on my device). When I start iterating, the floating point error occurs. Even when I set courant number to 0.1 and at the mass flow inlet boundary ant pressure outlet boundary all turbulence values to 0.1 (k-epsilon) the floating point error occurs before the first iteration is finished. What is wrong? Any help is highly appreciated! Ralf |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 08:56 |
exhaust gas simulation | jai | CFX | 1 | November 23, 2009 04:23 |
Gas plume or flare simulation | ahourri | FLUENT | 0 | November 14, 2005 09:23 |
ideal gas law in turbulent flow | Achim | Siemens | 0 | March 26, 2003 14:38 |
Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |