|
[Sponsors] |
September 27, 2005, 03:48 |
Gambit Meshing Problems
|
#1 |
Guest
Posts: n/a
|
Hi all, I try to create a volume mesh in Gambit, this is not for me the first time I do this but...... Appear ever the same message: Inizialization failed; perturb boundary nodes and try again.... This is usually caused by problems in the face meshes. Check the skewnesses of your face meshes and make sure the face mesh sizes are not too large in areas of small gaps. What i have to do? Thanks Francesco B.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
is free meshing or mapped meshing is best for flow problems | shanu | Main CFD Forum | 0 | February 18, 2010 11:58 |
Meshing problems using Gambit | Vianney | FLUENT | 4 | May 30, 2009 03:45 |
meshing a fan using gambit | tony | FLUENT | 1 | February 15, 2008 00:28 |
Gambit: too long meshing time! | delsolman | FLUENT | 1 | January 29, 2008 19:06 |