Gambit - sliding mesh preparation mistake -- CFD Online Discussion Forums

October 19, 2005, 04:06	Gambit - sliding mesh preparation mistake	#1
Maciej Guest Posts: n/a	Helo, I made quite complicated geometry for sliding mesh but forgot about that both sliding zones must have its own boundary face. Now both zones share one interface face (this face is used by 2 volumes). It seems now that I have to start the work again because adding the second interface face seems to be impossible due to some "references to upper topology entity". How can I add second face to any of the zones (volumes) to make an interface later in Fluent? regards Maciej

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
Moving mesh	Niklas Wikstrom (Wikstrom)	OpenFOAM Running, Solving & CFD	122	June 15, 2014 06:20
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
sliding mesh using Gambit	vivek	FLUENT	2	February 21, 2012 05:44
sliding mesh with gambit	Gopal Kasat	FLUENT	1	February 15, 2010 12:32

All times are GMT -4. The time now is 21:22.