|
[Sponsors] |
February 15, 2006, 14:01 |
how to continue fluent job
|
#1 |
Guest
Posts: n/a
|
hello I wonder if it is possible to continue a fluent job after I have saved the data at periodic intervals. eg. up to 1.5seconds then i plan to compute from 1.5s onwards. Anybody can please help?
Thanks in advance, juliana p |
|
February 15, 2006, 14:12 |
Re: how to continue fluent job
|
#2 |
Guest
Posts: n/a
|
I think what you're looking for is the autosave function... File->Write->Autosave
Hope this helps, and good luck, Jason |
|
February 16, 2006, 03:14 |
Re: how to continue fluent job
|
#3 |
Guest
Posts: n/a
|
Just load the .dat file you saved after 1.5s (and an appropriate .cas file, of course) and start iterating without initializing...
Hope this helps Edi. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
Job offer as support engineer (Fluent and CFX) | Far | FLUENT | 0 | October 10, 2011 04:43 |
Fluent 6.3 32bit vs Fluent 12.0 64bit | ibex7 | FLUENT | 7 | April 18, 2011 02:44 |
How about FLUENT user's job prospect? | CFDHunnter | FLUENT | 3 | November 5, 2003 16:01 |
cfd job | Dr. Don I anyanwu | Main CFD Forum | 20 | May 17, 1999 15:13 |