|
[Sponsors] |
October 17, 2006, 01:21 |
problems with VERY simple mesh
|
#1 |
Guest
Posts: n/a
|
Hi!
I have a very simple mesh in gambit (2D, about 5000 tri cells, only 10 cells with an equiSize Skew higer than 0.22). Now, exporting to and importing in Fluent is no problem. Performing a grid check is ok as well. Now, I turned the solver to axissymmetric and activate k-epsilon modell. After that, a new grid chek failed: WARNING: non-positive volumes exist. Waht happend??? ANY idea?? Ralf |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Using a hybrid mesh for a simple pipe | Udio_NT | ANSYS Meshing & Geometry | 17 | October 18, 2012 14:42 |
[GAMBIT] Error on simple mesh | Rich1979 | ANSYS Meshing & Geometry | 3 | August 16, 2010 05:21 |
[snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |