|
[Sponsors] |
May 22, 2007, 07:35 |
How to set interfacial roughness
|
#1 |
Guest
Posts: n/a
|
Hi all: I have stratified (air-water) flow within a pipe , the water flow in the button of pipe and air in the top and I am use the VOF model. I have the roughness value at interface between the phases from experiments and I did not know how to set it? Is there anybody can assist me with it?
Thanks in advance Saleem |
|
June 6, 2007, 23:42 |
Re: How to set interfacial roughness
|
#2 |
Guest
Posts: n/a
|
in boundary conditins menu, select and set the conditions for the wall for which you want to set the roughness, then select the momentum panel and set the value for the roughness.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Installation problems | indy | OpenFOAM Installation | 7 | April 3, 2009 09:40 |
OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Problems with installation of OpenFoam | sheyer | OpenFOAM Installation | 8 | July 28, 2008 03:45 |
Problem installing on 64bit with ver13 | jonititan | OpenFOAM Installation | 0 | April 28, 2006 05:45 |
Problems with installation | jonititan | OpenFOAM Installation | 4 | November 6, 2005 04:16 |