|
[Sponsors] |
September 27, 2007, 19:33 |
How to mesh a conical pipe?
|
#1 |
Guest
Posts: n/a
|
Hi,
I want to mesh a conical pipe and the diameters of both the open ends are 76 mm and 10 mm; respectively. Thus the smaller diameter is very small as compared to bigger one. I was just playing with different meshing scheme possibility. I would be highly thankful to you if you can share your experience of meshing conical pipe with me. Cooper option doesn't suits as one diameter is just 10 mm. your views are highly welcome. Thanks a ton, KM. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
[blockMesh] generate a graded pipe mesh. | jenright | OpenFOAM Meshing & Mesh Conversion | 0 | August 22, 2009 08:58 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
stuctured mesh 4 a y pipe | toni | Main CFD Forum | 2 | October 17, 2001 12:51 |