|
[Sponsors] |
October 5, 2007, 05:19 |
Problem with 2D ICEM mesh check in fluent
|
#1 |
Guest
Posts: n/a
|
Hello everyone! I created a 2D mesh in ICEM but when I import it in fluent 6 I have a warning during check mesh: "mesh has negative volumes!" What's the problem? If someone can help me I thank him very much.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
[ICEM] Meshing problem from ICEM CFD to Fluent | cfdonlinederafa | ANSYS Meshing & Geometry | 2 | September 21, 2010 16:16 |
Importing ICEM mesh to Fluent | mr_stoked | FLUENT | 1 | June 25, 2010 03:24 |
prob while exporting icem cfd hexa mesh to fluent | mani | CFX | 4 | March 7, 2007 03:41 |