 |
 |
 |
|
|
|
[Sponsors] | ||||
October 7, 2008, 23:29
|
fluent-Incylinder-problem-FATAL ERROR
|
#1 |
|
Guest
Posts: n/a
|
Hi Everyone, I am trying to simulate a 3-d incylinder model using fluent 6.3 solver,after defining the mesh in gambit and then importing into fluent solver,I defined the dynamic mesh motion model,once that stage is over when I tried to simulte the mesh motion, I recieved the following ERROR message: FLUENT recieved fatal signal (ACCESS_VIOLATION) 1.Note exact events leading to error. 2. save case /data under new name. 3.Exit program and restart to continue. 4. Report error to your distributor. error object
 )Could any one guide me on how to solve this problem?-please. |
|
|
||
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Ascii Fluent msh OF Fatal IO Error regIOobjectReadC at line 66 | sponiar | OpenFOAM Meshing & Mesh Conversion | 4 | December 12, 2008 18:42 |
| fatal error | hossein | FLUENT | 1 | May 6, 2008 08:30 |
| CFX fatal error | Steven | CFX | 0 | February 23, 2008 06:10 |
| Fatal error error writing to tmp No space left on device | maka | OpenFOAM Installation | 2 | April 3, 2006 08:48 |
| fatal error | helen | CFX | 3 | February 20, 2004 10:26 |
Threaded Mode
