|
[Sponsors] |
November 11, 2008, 03:35 |
Fluent reaction- udf problem? help
|
#1 |
Guest
Posts: n/a
|
Fluent reaction- udf problem? I have defined a surface reaction by my udf(it is different from the arrhenius rate) ,and have hooked it in the fluent. But I can't find any change in the reaction panel,that is to say I can't find the reaction rate just defined, there is only a arrhenius reaction rate. 1.Does it has adopt the user defined reation by default or is my mistake? 2.If it has adoptde the udf's rate by default ,then how can I set up the stoich coefficient or there is no need to set up it at all?
Thans in advance ! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
chemical reaction problem | Benoit | FLUENT | 2 | March 14, 2013 14:56 |
surface Reaction in Fluent through UDF | Hamis Jumanne | Fluent UDF and Scheme Programming | 1 | July 2, 2012 07:47 |
Fluent reaction problem? Help | zheheng | FLUENT | 1 | December 6, 2008 04:29 |
reaction problem | babak | FLUENT | 3 | November 11, 2006 13:16 |
Plz help! I can't express this reaction in fluent | chang,antony | FLUENT | 0 | September 8, 2002 03:31 |