|
[Sponsors] |
December 28, 2010, 11:11 |
what is the best way to mesh a cylinder
|
#1 |
New Member
ramila.h
Join Date: Dec 2010
Posts: 29
Rep Power: 15 |
Hello,
I tried meshing a cylinder, by using the cylinder from 'geomtry', then I meshed it using Tetrahedral/ hybrid mesh using interval size 0.01 but the results were not so good Can you tell me please, what's a best way to mesh a cylinder? thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
rotating cylinder using sliding mesh | Tim Daly | FLUENT | 1 | November 9, 2008 23:02 |
ICEM block mesh with a ball in a cylinder tube | Li | CFX | 6 | August 11, 2008 05:44 |
mesh problem for cylinder | akr | FLUENT | 1 | January 29, 2007 23:43 |