|
[Sponsors] |
May 24, 2011, 20:16 |
Bleed using Porous Jump
|
#1 |
New Member
Mohan
Join Date: Mar 2011
Posts: 21
Rep Power: 15 |
Hello people,
Is it possible to specify permeability simply as a ratio of areas? In my case, I have an area through which I have air flow. Now I want results for varying areas and it'd be much more time efficient if I could use a permeability setting to tell fluent, essentially, how much of the area is permeable. This would save me from rebuilding the area geometry and remeshing. Can his be done in Fluent? Thanks ^_^ |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] How can I define different zones in ICEM? | llrr | ANSYS Meshing & Geometry | 14 | February 12, 2017 13:44 |
[Commercial meshers] Porous Jump creation problem | mulfal | OpenFOAM Meshing & Mesh Conversion | 4 | December 9, 2013 11:59 |
Porous jump in urban environment | samygero | FLUENT | 0 | February 14, 2011 18:26 |
Porous Jump | Naresh | FLUENT | 0 | April 25, 2007 15:36 |
Testing the integrity of POROUS media and por jump | Azman | FLUENT | 0 | July 31, 2006 11:11 |