Gridpro to ICEM: "Demo Version: Output Disabled" and

dreamchaser · April 13, 2017, 09:37

Dear All,

I am sorry but I am not too familiar with GridPro so I am sorry in advance for asking bad questions.

I received gridpro files that contained the topology information including: mesh.fra, mesh.sch. I loaded the topology information (.fra file) successfully. I tried to start the grid process by going to topo and then selecting Ggrid start but I was getting a message "Demo Version: Output Disabled". Does anyone know why I am getting this message?

I am using the linux trial version of grid pro. My main goal is to import the geometry and mesh into ICEM. If I am not able to generate the mesh in gridpro, is it possible to import the surface files (.fra) directly into ICEM?

Thanks in advance,

dreamchaser

vijaiaeroastro · April 26, 2017, 00:26

Hey there,

Looks like you don't have a valid license. If you are a student, you can signup at http://www.gridpro.com/join and request a 250 block license for free

Vijai

April 13, 2017, 09:37	Gridpro to ICEM: "Demo Version: Output Disabled" and	#1
dreamchaser Member Mike Join Date: Jun 2012 Posts: 58 Rep Power: 13	Dear All, I am sorry but I am not too familiar with GridPro so I am sorry in advance for asking bad questions. I received gridpro files that contained the topology information including: mesh.fra, mesh.sch. I loaded the topology information (.fra file) successfully. I tried to start the grid process by going to topo and then selecting Ggrid start but I was getting a message "Demo Version: Output Disabled". Does anyone know why I am getting this message? I am using the linux trial version of grid pro. My main goal is to import the geometry and mesh into ICEM. If I am not able to generate the mesh in gridpro, is it possible to import the surface files (.fra) directly into ICEM? Thanks in advance, dreamchaser

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
OpenFOAM-1.6 install cookbook	MadsR	OpenFOAM Installation	372	November 20, 2010 11:57
9.4 version...is it possible to analyse the output of a 9.3 simulation??	sdr	FLOW-3D	6	February 12, 2010 04:57
paraFoam reader for OpenFOAM 1.6	smart	OpenFOAM Installation	13	November 16, 2009 21:41
ICEM last version?	Juan	CFX	4	April 4, 2006 09:22
Free seminar: ICEM CFD version 5.0	Gavin Butcher	CFX	0	June 17, 2004 10:49

April 26, 2017, 00:26		#2
vijaiaeroastro New Member Vijai Kumar S Join Date: Oct 2012 Location: India Posts: 2 Blog Entries: 1 Rep Power: 0	Hey there, Looks like you don't have a valid license. If you are a student, you can signup at http://www.gridpro.com/join and request a 250 block license for free Vijai